NFC driver programming

Programming of compatible TCI drivers via "NFC or DALI interface"

The manufacturer TCI uses a new technology for transmission standards, the standardised programming of NFC drivers. With the latest generation of the TCI NFC LED driver, equipped with an NFC interface that offers programmable functions, you are ideally equipped for your project.

Programmable functions:

• AOC Adjustable output current (Current) *, in the range (minimum to maximum) of the respective driver as specified in the data sheet. The output current of these LED power supply units can be precisely programmed in 1mA steps.
• Push dimming
• Corridor function
• CLO* ( Constant Lumen Output)
• 0/1-10V
• DC level (emergency)*
• Midnight
• NTC

Output current* = Individual control of the current output in mA

CLO* = The decrease in luminous flux of an LED module can be compensated over the entire service life by a pre-programmed current curve. The decreasing luminous flux and the lifetime value are normally provided directly by the LED chip manufacturer using TM21 and the associated LM report (e.g. LM80B20).
This not only ensures stable lighting, but also saves energy and increases the service life of the LEDs.
Hours time step x/20: Setting the hours (minimum setting 5khrs).
Value % time step x/20: Setting the increasing brightness.

DC level* = Many LED drivers are equipped with functions for emergency lighting. The software can be used to set the percentage light or power value in emergency power mode ( DC mode).

NFC* = The NTC interface is a thermal fuse for the LED modules to reduce the current when critical temperatures are reached. The temperature reduction can be configured via an external NTC resistor connected to the driver.

We offer you the NFC programming service

Select the NFC driver suitable for your project from our Portfolio.
1. define the output current, we will programme the desired output current into your NFC driver.
2 For online orders, the "Your comment" field is available for transmitting the parameter. 
3. add the NFC programming service per number of drivers to the shopping basket (the cost of programming is per power supply unit).
4. add the item Set up measuring station once.

!!! When selecting, the programmable properties of the respective driver must be observed. !!!