NFC-B Programming Tool - ID CPR30+

NFC programming tool for LED drivers with NFC interface | TCI 127101

This TCI 127101 NFC programmer and the associated ‘DALI-NFC Multi Tag’ programme can be used to configure the NFC programmable LED supply units from TCI. Depending on the driver, the following properties can be programmed:

Programmable functions:

• AOC Adjustable output current (Current) *, in the range (minimum to maximum) of the respective driver as specified in the data sheet. The output current of these LED power supply units can be precisely programmed in 1mA steps.
• Push dimming
• Corridor function
• CLO* ( Constant Lumen Output)
• 0/1-10V
• DC level (emergency)*
• Midnight
• NTC

Output current* = Individual control of the current output in mA

CLO* = The decrease in luminous flux of an LED module can be compensated over the entire service life by a pre-programmed current curve. The decreasing luminous flux and the lifetime value are normally provided directly by the LED chip manufacturer using TM21 and the associated LM report (e.g. LM80B20).
This not only ensures stable lighting, but also saves energy and increases the service life of the LEDs.
Hours time step x/20: Setting the hours (minimum setting 5khrs).
Value % time step x/20: Setting the increasing brightness.

DC level* = Many LED drivers are equipped with functions for emergency lighting. The software can be used to set the percentage light or power value in emergency power mode ( DC mode).

NFC* = The NTC interface is a thermal fuse for the LED modules to reduce the current when critical temperatures are reached. The temperature reduction can be configured via an external NTC resistor connected to the Driver.